5 of 11
INITIAL KEYPAD CONFIGURATION NOTES
The TS2 keypads are automatically added to the system using the configurator and can not be added
manually. Use the following procedure to make initial keypad connections to the system.
1. Connect and power up all keypads per the connections diagram below. The keypads should boot to
a screen with an option to GET ADDRESS. If the keypad does not boot to the GET ADDRESS
screen then follow the steps below:
a. Press the service menu button (located behind bezel and below Mini-USB connection and
light sensor) once to access the MAIN MENU screen.
b. Press the UP/DOWN buttons to highlight VNet addr then press the Enter button.
c. Press the UP/DOWN buttons to highlight Reset addr then press Enter.
2. In the configurator, click on the interface tab and add the SC1 as a communication device then select
the COM port that it is connected to. See HomeLogic Configuration Details below.
3. On the TS2 (OleXL) keypad, verify the GET ADDRESS menu item is highlighted and press the Enter
button. The keypad will receive an address from the controller and display it at the top of the screen.
Note: If more than one keypad is to be installed it may be helpful to make note of the address and the
physical location of the keypad to aid in selecting the proper control zones in the following steps.
4. On the TS2 (OleXL) keypad, with the OK menu item highlighted press Enter. The controller will
check the keypad program and download any required information to it. Be patient this may take up
to 5 minutes.
5. Repeat steps 1-4 until all keypads have been added.
6. Using the address noted in step 3 identify each keypad on the Interface Tab and configure the
desired zones, partitions, control, and backlight behavior. See HomeLogic Configuration Details
below.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales